Description
1. Clean the Surface
a. Wash the area where the decal will be applied using mild soap and water or isopropyl alcohol.
b. Dry thoroughly with a clean microfiber cloth.
Note: The surface must be smooth, dry, and free of dirt, wax, or grease.
2. Position the Decal
a. Without removing the backing, place the decal on the vehicle to find the desired position.
3. Peel the Backing
a. Starting from the white corner (top right), slowly peel off the backing paper, making sure the decal stays attached to the clear transfer tape.
4. Apply the Decal
a. Starting from the top, slowly press the decal onto the surface using a squeegee or credit card.
b. Work from the center outward to remove any air bubbles.
5. Smooth It Out
a. Firmly press and smooth over the entire decal using the squeegee or credit card.
b. Pay special attention to the edges and tips of the star.
6. Remove the Transfer Tape
a. Slowly peel off the clear transfer tape from the white corner (top right) at a sharp angle.
b. If any part of the decal lifts, press it back down and wait a few more minutes before trying again.
7. Final Check
a. Inspect the decal for any air bubbles.
b. Small bubbles can be gently pushed out with the edge of a squeegee, or pricked with a pin and smoothed down.
